Hard Disk Test Detail Status - Toshiba T4500 User Manual

NDP
(T4600/T4600C
only)

3.15 Hard Disk Test Detail Status

When an error occurs in the hard disk test, the following message is displayed:
HDC status = XXXXXXXX
Detailed information about the hard disk test error is displayed on the screen by an eight-digit
number. The first four digits represent the hard disk controller (HDC) error status number and the
last four digits are not used.
The hard disk controller error status is composed of 2 bytes. The first byte displays the contents of
the HDC status register in hexadecimal form and the second byte displays the HDC error register.
The contents of the HDC status register and error register are described in Tables 3-4 and 3-5.
Table 3-4 Hard Disk Controller Status Register Contents
Bit Name
7 BSY
(Busy)
6 DRDY
(Drive ready)
5 DWF
(Drive write fault)
4 DSC
(Drive seek
complete)
3 DRQ
3-34
CC Write Fault
E0 Status Error
01 No CO-PROCESSOR
02 Control Word Error
03 Status Word Error
04 Bus Error
05 Addition Error
06 Multiplication Error
Description
"0" ---HDC is busy.
"1" ---HDC is ready.
"0" ---Hard disk drive is not ready to accept any command.
"1" ---Hard disk drive is ready.
"0" ---DWF error is not detected.
"1" ---Write fault condition occurred.
"0" ---The hard disk drive heads are not settled over a track.
"1" ---The hard disk drive heads are settled over a track.
"0" ---Drive is not ready for data transfer.