Toshiba T4500 User Manual page 162

Installing the Monochrome Liquid Crystal Display Module
To install the T4500/T4600 liquid crystal display module, follow the steps below and refer to
Figures 4-44 through 4-46.
1. Connect the two display cables to CN1 and CN2 on the LCD module (Figure 4-45).
2. Place the module in the cover and route the cables so they will not be pinched by the dis-
play panel or other component and secure them with tape (Figure 4-46).
3. Secure the panel with four M2.5x4 screws (Figure 4-44).
4. Secure the ground cable with one M2.5x4 screw (Figure 4-46).
5. Install the display mask, display assembly, top cover, optional PCMCIA card, optional
memory card and battery pack as described in Sections 4.13, 4.9, 4.5, 4.4, 4.3 and 4.2.
Figure 4-46 Routing the Display Cables
4-47