5. Select the desired subtest number from the subtest menu and press Enter.
The following message will appear:
TEST LOOP : YES
ERROR STOP: YES
Use the arrow keys to move the cursor to the desired options and press Enter.
Selecting YES for the TEST LOOP sets the test to run continuously until it is halted by the
user. Selecting NO returns the sub-test menu to the main menu after the test is complete.
Selecting Yes for ERROR STOP stops the test program when an error is found and desplays
the operation guide on the right side of the display screen as shown below:
ERROR STATUS NAME
These three selections have the following functions:
1: Terminates the test program and exits to the subtest menu.
2: Continues the test.
3: Restarts the test from the beginning.
Use the arrow keys to move the cursor to the desired option and press Enter. Selecting NO
for ERROR STOP keeps the test running even if an error is found.
Table 3-1 in Section 3.3 describes the function of each test on the subtest menu, and Table 3-3 in
Section 3.13 describes the error codes and error status for each error.
3-4
[[ HALT OPERATION ]]
1: Test end
2: Continue
3: Retry