Fuji Xerox DocumentCentre C400 Series User Manual page 23

Do not unplug or replug the machine while it is on. Unplugging a live connector can deform
the plug and cause fire.
When unplugging the machine, grasp the plug instead of the cord. Forcibly pulling on a cord
can damage it and cause fire or electric shock.
The machine has a circuit breaker. In the event of a current leakage, the breaker will auto-
matically cut off the power circuit to prevent any leakage or fire from occurring. The breaker
is normally On ("l"). Once a month, check the breaker for correct operation. Also, make sure
that it is earthed. If not, the breaker cannot detect the current leakage which can cause
electric shock. Check the breaker by using the following procedure. If you notice any
unusual conditions, contact our Customer Support Center.
1. Turn the machine Off.
2. Push in the breaker's reset button. The reset button stays pressed in when you take your
finger away from the button.
3. Lightly press the Test button with the tip of a ball-pen or other fine-tipped object. The
reset button is released and springs back out. This completes the check.
4. Press the reset button again to press in the button.
When the machine is not used over an extended period of time, switch it off and unplug it. If
an unused machine is left connected to a power source for a long period, degraded insula-
tion can cause electric shocks, current leakage or fire.
Be sure to switch off and unplug the machine before accessing the interior of the machine
for cleaning, maintenance or fault clearance. Access to a live machine's interior can cause
electric shock.
Be sure to switch off and unplug the machine before accessing the interior of the machine
for accessing interface cables, maintenance or fault clearance. Access to a live machine's
interior can cause electric shock.
Power switch
Reset button
Test button
xxi