Fuji Xerox DocumentCentre C400 Series User Manual page 152

5.4 Setting the System Settings (Common Settings)
6. Auto Job Release
Set to release the current job to enable execution of the next job when an unusual condition (docu-
ment jam, paper jam, etc.) occurs on the machine during copying or scanning. At this time, the job
can be executed only at sections on the machine that are functioning normally. Set the time until the
job is released to within 240 to 5940 seconds (4 to 99 minutes) in 60-second increments.
Enter the setting value using the numeric keypad.
(Default is 600 (seconds).)
Setting Value
240 to 5940
7. Auto Print
Set whether or not to automatically enable execution of print jobs when the machine is not operated
for a fixed period of time. Set the time until execution of print jobs is enabled to within 1 to 240 sec-
onds in 1-second increments. Enter the setting value using the numeric keypad.
(Default is 10 seconds.)
Setting Value
5
8. Auto Power Saver
The Power Saver feature has two modes, a Low Power Mode and a Sleep Mode. When the preset
time has elapsed, the mode changes as follows to lower the machine's power consumption.
Last Selection → Low Power Mode → Sleep Mode
At this item, set the time until the machine enters the Low Power Mode and the time until the
machine enters the Sleep Mode.
Set the time up to the Low Power Mode within the range 6 to 240 minutes and the time up to the
Sleep Mode within the range 0 to 234 minutes in 1-minute increments.
As each of these times are time settings from the last selection, the time from the Low Power mode to
the Sleep mode is Sleep Mode-Low Power Mode.
(Default for From Last Selection to Low Power Mode is 15minutes, for From Low Power
Mode to Sleep mode is 45minutes.)
The Low Power Mode cannot be set to disabled. Set this item so that the total of the setting values is within 15 to
240 minutes.
For details about the Power Saver mode, see "1.3 Power Saver Mode" (P. 19).
q
When setting the time up to the Sleep Mode, set Sleep Mode to Enable referring to "5.4.9 Migration to Sleep
q
Mode and Offset Settings (Others)" (P. 138).
124
0 Do not automatically release the job.
Set the time until the job is released in 60-second increments.
0 The time is not set. Output is started immediately when the machine
is ready.
1 to 240 Set the print start time in 1-second increments.
Description
Description