Fuji Xerox DocumentCentre C400 Series User Manual page 189

SMB
Set the following items when using SMB.
sPort Status
Set whether to Enabled or Disabled the SMB port status when the power is turned on.
(Default is Enabled.)
When the port status is set to Enabled, the port status is sometimes automatically set to Disabled if there is insuf-
ficient memory. If this happens, either set the status of the unused port to Disabled, or change the assigned mem-
ory size.
IPP
Set the following items when using IPP:
sPort Status
Set whether to Enabled or Disabled the IPP port status when the power is turned On.
When IPP is used, set to Enabled.
(Default is Disabled.)
The IP address must be set to start the IPP port.
When the port status is set to Enabled, the port status is sometimes automatically set to Disabled if there is insuf-
ficient memory. If this happens, either set the status of the unused port to Disabled, or change the assigned mem-
ory size.
EtherTalk
Set the following items when using EtherTalk. This item is displayed when the PostScript Software
Kit is installed.
sPort Status
Set whether to Enabled or Disabled the EtherTalk port status when the power is turned on. When
EtherTalk is used, set to Enabled.
(Default is Disabled.)
When the port status is set to Enabled, the port status is sometimes automatically set to Disabled if there is insuf-
ficient memory. If this happens, either set the status of the unused port to Disabled, or change the assigned mem-
ory size.
5.6 Network Settings
5
161