Fuji Xerox DocumentCentre C400 Series User Manual page 105

Symptoms
Images on the copy Is the document loaded correctly?
are skewed.
Is paper loaded correctly in the tray?
Are the paper guides in tray 5 (Bypass
Tray) set so that they are contacting
the paper?
Is the DADF document guide at the
correct position?
Is the paper tray set properly?
Part of the image is Is the paper damp?
missing on the
copy.
Is the loaded paper folded or wrin-
kled?
Is the document pasted together or
folded in?
A stripe pattern Is too large a document enlargement
appears in copies. ratio set?
Check
Load the document correctly.
See "1.2 Loading Documents" (P. 270) in
"Part 2 Copier".
Load paper correctly.
"2.1 Loading Paper" (P. 28)
Load the document correctly, and align
the document guide with the edge of the
document.
See "1.2.2 Loading Copies on the DADF"
(P. 271) in "Part 2 Copier".
Firmly push in the tray as far as possible
to set it properly.
"2.1 Loading Paper" (P. 28)
If the paper is damp, either some parts
of the copy are not shown or the copy is
smudged and unclear. Replace with
paper from a new ream.
"2.1 Loading Paper" (P. 28)
Remove the defective paper and replace
with paper from a new ream.
"2.1 Loading Paper" (P. 28)
A probable cause is that the pasted or
folded in section is curling back, and has
risen up from the surface of the docu-
ment glass. Place a stack of white
sheets on the document to hold the doc-
ument down flat against the document
glass.
Stripes sometimes appear in copies at
some enlargement ratios. Adjust the
copy enlargement ratio.
See "3.4 Making Enlarged/Reduced Copies -
Reduce/Enlarge" (P. 306) in "Part 2
Copier".
4.2 Initial Checks
Remedy
4
77