Fuji Xerox DocumentCentre C400 Series User Manual page 187

sPJL
On this machine, PJL commands that are not reliant on print language can be used. PJL commands
are used for controlling print jobs, and are required when printing by a printer driver. Set whether to
enable or disable PJL commands that are sent from the client. If PJL commands are used, the print
language of the next data to arrive can be specified whichever print language the machine is using for
processing print data at that time. Normally, set this item to Enabled.
(Default is Enabled.)
When a print language not installed on this machine is specified by the PJL command, the data will be erased.
sAuto Eject Time
Set the time to wait until automatically ejecting data remaining in the machine's memory when data
is not being received.
Any time can be set within the range 5 to 1275 seconds in 5-second increments. When the next data
is not received within the time set here after the last data was received, the machine judges that the
job has ended.
(Default is 30 seconds.)
sAdobe Communication Protocol
Set the PostScript communications protocol. This item is displayed when the PostScript Software Kit
is installed.
(Default is Standard.)
Standard
..........................Set this when the communications protocol is ASCII format.
Binary
..........................Set this when the communications protocol is binary format. With some data, the
data is processed for printing faster than the Standard setting.
TBCP ................Set this when the communications protocol is a mixture of ASCII format and binary
format, and these formats are switched by specific control codes.
Set the protocol to match the format of the data output by the client's printer driver.
q
Normally, use at the default setting Standard.
q
The setting here is enabled only when the Print Mode is set to PostScript.
q
sBi-directional Communications
Set whether or not to enable Bi-directional Communications (IEEE1284) on the parallel interface.
(Default is Enabled.)
sInput Prime
Set whether to enable or disable INPUT_PRIME control (hardware reset). When the INPUT_PRIME
signal is received, reset processing is performed.
(Default is Enabled.)
With some clients, the INPUT_PRIME signal is output and reset processing is performed each time printing is
performed. So, the details of menu operations specified on the control panel are sometimes not reflected in the
printed result. If this happens, the details of menu operations can be reflected by setting this item to Disabled.
This setting is used with HP/GL-2.
5.6 Network Settings
5
159