Fuji Xerox DocumentCentre C400 Series User Manual page 107

Symptoms
Paper is often Is paper loaded properly in the tray?
jammed or wrin-
kled.
Is the paper tray set properly?
Is the paper damp?
Is the paper curled?
Are there any torn pieces of paper still
remaining inside the machine or is
there a foreign object in the machine?
Is out-of-spec paper loaded in the
tray?
Is paper loaded in the tray past its
maximum fill line?
Is the paper guide set correctly?
Documents are not Are the documents too small?
fed into the DADF.
Check
Load paper correctly.
"2.1 Loading Paper" (P. 28)
Firmly push in the tray as far as possible
to set it properly.
"2.1 Loading Paper" (P. 28)
Replace with paper from a new ream.
"2.1 Loading Paper" (P. 28)
Either turn the paper so that the curl is
facing down in the tray, or replace with
paper from a new ream.
"2.1 Loading Paper" (P. 28)
Open the door of the machine or slide
out the tray to remove the torn paper or
the foreign object.
"2.1 Loading Paper" (P. 28)
Replace with paper that meets machine
specifications.
"2.1 Loading Paper" (P. 28)
q
Paper Recommendations
q
Load paper in the tray so that it does not
exceed the maximum fill line.
"2.1 Loading Paper" (P. 28)
Load the document correctly, and apply
the paper guide to a paper lightly.
The minimum size of the document that
can be loaded on the DADF is A5.
See "1.2 Loading Documents" (P. 270)" in
"Part 2 Copier".
4.2 Initial Checks
Remedy
4
79