Section 4: Parts and Module Replacement
3. Disconnect the LiteLOC sensor harness.
4. Remove the 2 screws securing the LiteLOC sensor and then loosen the bottom screw.
5. Remove the 4 screws.
6. Remove the fold mirror by handling only the edges.
7. Install the new fold mirror:
a. Touch the edge of the mirror face to ensure there is no gap between your finger and its reflection.
a. Mount the fold mirror with the reflective surface facing into the projector.
b. Install the 4 screws.
8. Install the LiteLOC sensor and reconnect the harness.
9. Adjust fold mirror. See
4-32
Fold Mirror
Adjustment.
J Series 2.0, 2.4, and 3.0kW Service Manual
020-100739-01 Rev. 1 (01-2012)