Inspect Power Supplies And Power Cords; Replace The Filter; Inspect And Clean Optics - Christie J series 2.0kW Service Manual

Section 2: Service Guidelines

2.0.3 Inspect Power Supplies and Power Cords

WARNING
power range.
CAUTION
Ensure that you are using a power cord, power plug, and socket that is rated for your location.
You should never open or repair a failed power supply. If a power supply fails, contact Christie support and
request a replacement.
The use of accessories that are not approved by Christie can result in fire, shock, or personal injury.
Replace the
2.0.4
CAUTION
You should check the condition of the air filter every 1000 hours or sooner if you are operating the projector in
a dusty or dirty environment. The filter is located on the front of the projector beside the lens.
1. Loosen the lock screw at the top of the filter door. Lift the door away from the projector.
2. Remove the old filter and insert the new filter with the directional arrows pointing into the projector.
3. Replace the filter door and tighten the lock screw.

2.0.5 Inspect and Clean Optics

Unnecessary cleaning of optics can increase the risk of degrading delicate coatings and surfaces. Always wear
nitrile gloves.
2-2
Do not operate the projector if the AC supply is not within the specified voltage and
An appropriate rated power cord for the country of use is provided with each projector.
Filter
Use only Christie approved filters.
J Series 2.0, 2.4, and 3.0kW Service Manual
020-100739-01 Rev. 1 (01-2012)