Fold Mirror Adjustment; Integrator Assembly Adjustment - Christie J series 2.0kW Service Manual

Section 4: Parts and Module Replacement
5. Tighten the setscrews so they will not shift and then check the boresight again.
4.7

Fold Mirror Adjustment

If a corner or edge of the image is missing, the fold mirror might be misaligned with the optical system. To
correct this issue:
1. Unlock the 2 setscrews.
2. Turn the pivot screw 90-180 degrees.
3. Adjust both cap screws, to move the fold mirror forward and back.
4. Tighten the 2 setscrews and pivot screw.
4.8

Integrator Assembly Adjustment

1. Remove the side cover:
a. Loosen the 6 quick-release screws.
b. Remove the cover and set it aside.
2. Turn the projector on.
3. Using the remote, press Test for the white test pattern.
4. Locate the integrator adjustment knob.
5. Loosen the knob.
6. Move the knob up and down to create a shadow at each corner of the image.
7. Move the knob forward and backward to get the best focus.
4-48 J Series 2.0, 2.4, and 3.0kW Service Manual
020-100739-01 Rev. 1 (01-2012)