Christie J series 2.0kW Service Manual page 29

8. Remove the 2 screws at bracket-to-baseplate points.
9. Remove the 4 screws at bracket-to-lamp housing points.
10. Disconnect the harness for 2.0, 2.4, and 3.0kW:
a. AC relay and capacity cable from terminal block (TB) and Ground (G).
b. AC blower cable from AC relay and capacity cable.
11. Disconnect the harness for 2.0kW and 2.4kW:
a. AC Input cable from TB and G.
12. Disconnect the harness for 2.4kW and 3.0kW:
a. TB cable from line filter (rear side connection).
13. Remove the AC blower and bracket assembly.
14. Replace AC blower.
J Series 2.0, 2.4, and 3.0kW Service Manual
020-100739-01 Rev. 1 (01-2012)
Section 4: Parts and Module Replacement
4-9