Remove And Replace The Ac Power Switch (3.0Kw) - Christie J series 2.0kW Service Manual

Section 4: Parts and Module Replacement
5. Disconnect the 4 AC switch connectors.
6. Unlock and remove the AC power switch.
7. Install the new AC power switch.

4.5.12 Remove and Replace the AC Power Switch (3.0kW)

1. Power down the projector:
a. Turn the projector off and allow the projector to cool for a minimum of 5 minutes.
b. Disconnect the AC power cord from the rear of the projector.
2. Remove the locking pin from the bracket surrounding the AC receptacle at the AC inlet.
3. Remove the 2 screws from the AC inlet bracket.
4. Remove the rear cover:
a. Loosen the 8 quick-release screws on the rear cover.
b. Move the cover away from the rear of the projector to access the keypad PCB.
c. Disconnect the projector keypad harness connector P65.
d. Remove the rear cover and set it aside.
5. Remove the 8 screws from the AC cover panel.
6. Remove the 4 screws from the AC receptacle and then pull the left side of the AC cover panel towards you
while you slide the right side and pull it forward to access the AC power switch.
7. Disconnect the 4 AC switch connectors.
8. Unlock and remove the AC power switch.
9. Install the new AC power switch.
4-18 J Series 2.0, 2.4, and 3.0kW Service Manual
020-100739-01 Rev. 1 (01-2012)