Remove And Replace The Front Ir Sensor - Christie J series 2.0kW Service Manual

Section 4: Parts and Module Replacement
4. Remove the retention clip from the top of the foot.
5. Unscrew the foot and remove it from the projector.
6. Insert the threaded end of the replacement foot in the mounting hole and turn until tight.
7. Replace retention clip.

4.5.20 Remove and Replace the Front IR Sensor

1. Power down the projector:
a. Turn the projector off and allow the projector to cool for a minimum of 5 minutes.
b. Disconnect the AC power cord from the rear of the projector.
2. Remove the front cover:
a. Remove the 6 quick-release screws holding the front skin and then remove it and set it aside.
3. Disconnect the sensor connector.
4. Remove the 2 screws.
5. Remove the sensor
6. Install the front infrared sensor.
4-26 J Series 2.0, 2.4, and 3.0kW Service Manual
020-100739-01 Rev. 1 (01-2012)