Shutter; Lamps; Status Led; Electronics/Sw - Christie J series 2.0kW Service Manual

6.2.8 Shutter

Open
Closed

6.2.9 Lamps

Ushio Xenon bubble lamp system

6.2.10 Status LED

Status LEDs
Lamp
Comm
Status
Shutter

6.2.11 Electronics/SW

FEATURE
Image Device
Video Format Re-Sizing
Picture in Picture
Built-in 2D keystone and geometry correction
Auto-scaling
Auto-de interlacing
Edge blending
Warping
Tiling (max array size)
Blanking and Image positioning
Brightness, contrast, color, and uniformity
Image orientation
Electronics HW access
Number of option cards
Number of processor cards
Number of option slots
Arbitrary Gamma
J Series 2.0, 2.4, and 3.0kW Service Manual
020-100739-01 Rev. 1 (01-2012)
Light transmitted to projection lens
All light blocked - no light on screen
Lamps are accessed from the rear of the projector
#
1 Off – Lamp off
Yellow – Lamp time has expired and lamp should be replaced
Green – Lamp is on and operating correctly
Flashing red – Lamp has malfunctioned
Flashing yellow – Lamp door is open
2 Flashing red – Error has occurred. Details are displayed on the status display
3 Off – AC power is off
Yellow – AC is present but projector is in standby
Green – Power is powered up and operating normally
Flashing red – Error has occurred. Details are displayed on the status display
4 Green – Shutter is open
Yellow – Shutter is closed
COMMENTS
Supports 3 chip DMD operation
All video formats can be resized to fill screen either horizontally or
vertically while maintaining aspect ratio
Supported
Supported
Supported
Supported
Supported
Supported
3x3 Standard Image Processor & 2x2 Dual Image Processor
Supported
User settable control
Can display image front/rear screen, normal/inverted (ceiling)
Mounted at the back of the projector
6 user inter-changeable – hot swappable
2 user inter-changeable
4, option cards; 1, processor card
User definable gamma curves
Section 6: Specifications
LED STATES
6-5