Warning/Caution Symbols Used In This Manual; Meaning Of Symbols Used On The Equipment - Nikon eclipse lv150 Instruction Manual

Thank you for purchasing the Nikon products.
This instruction manual has been prepared for the users of Nikon's industrial
microscope "ECLIPSE LV150/LV150A."
To ensure correct usage, read this manual carefully before operating the instrument.
• It is prohibited to reproduce or transmit this manual in part or whole without Nikon's
expressed permission.
• The contents of this manual are subject to change without notice.
• Although every effort has been made to ensure the accuracy of this manual, if you
note any points that are unclear or incorrect, contact your nearest Nikon
representative.
• Some of the products described in this manual may not be included in the set you
have purchased.
• Be sure to read the instruction manual for any other products that may be used in
combination with the microscope.

Warning/Caution Symbols Used in This Manual

Although Nikon products are designed to provide you with the utmost safety during use,
incorrect usage or disregard of the instructions can cause personal injury or property
damage. For your safety, read this instruction manual carefully and thoroughly before
using the instrument. Do not discard this manual, but keep it near the product for easy
reference.
In this manual, safety instructions are indicated with the symbols shown below. Be sure
to follow the instructions indicated with these symbols to ensure correct and safe
operation.
Symbol
WARNING
CAUTION

Meaning of Symbols Used on the Equipment

Symbol
Meaning
Disregarding instructions marked with this symbol may lead
to death or serious injury.
Disregarding instructions marked with this symbol may lead
to injury or property damage.
Meaning
Caution for heat.
This marking on the rear of the lamphouse, and near the
lamphouse clamp screw on the illuminator (LV-UEPI and
LV-UEPI2), calls your attention on the following.
For the symbol position, see pages 10 and 12.
• The lamphouse is very hot during and immediately after
illumination.
• Risk of burns. Do not touch the lamphouse during and
immediately after illumination.
• Make sure that the lamphouse has sufficiently cooled
before replacing the lamp.
1