Software Installation; Winx; Lightfield; Figure 12. Winx Installation Select Installation Type Dialog - Princeton Instruments ProEM+ EMCCD User Manual

Chapter 4

Software Installation

WinX

Notes:
1. Install the GigE Adapter card BEFORE installing the WinX application software.
2. Leave the interface cable disconnected from the camera until you have installed
WinX (Ver. 2.6.10 or later).
The following installation is performed via the WinX software installation CD.
1. Insert the CD and follow the
2. On the Select Installation
3. Make sure the camera is connected to the host computer and that the camera power
4. Reboot the computer.
5. At bootup, Windows will detect the GigE card.

LightField

Note: Install the GigE Adapter card BEFORE installing the LightField application
software.
The following installation is performed via the LightField software installation CD.
1. Before starting the installation:
2. Insert the CD and follow the installation wizard prompts.
System Setup
installation wizard prompts.
Type dialog (see Figure 12),
click on the Typical radio
button to install the required
drivers and the most
commonly installed program
files. Select the Custom
radio button if you would
like to choose among the
available program files or do
not want to install the
drivers. Complete installs all
of the application features.
supply is turned on.

Verify that the computer operating system is Windows Vista (64-bit) or
Windows 7 (64-bit).

Confirm that the GigE adapter card has been installed.

Verify that your computer is connected to the Internet. Internet connection is
required for product activation if you have a software key.
Figure 12. WinX Installation
Select Installation Type dialog
35
35