Chapter 8 Troubleshooting; Introduction - Princeton Instruments ProEM+ EMCCD User Manual

Troubleshooting
Do not attach or remove any cables while the camera system is powered on.
WARNING!

Introduction

The following issues have corresponding troubleshooting sections in this chapter.
Acquisition Started but Data Display is Empty
Acquisition Started but Viewer Contents Do Not Update
Baseline Signal Suddenly Changes
Camera Not Found
Camera Stops Working
Camera1 (or similar name) in Camera Name field
Cooling Troubleshooting
Data Overrun Due to Hardware Conflict message
Device Is Not Found
Device is Occupied
Ethernet Network is not accessible
Program Error message
Serial violations have occurred. Check interface cable.
Smeared Images
TEC Fault LED comes on
WinX or LightField Crashes When Adding GigE Camera to System
Chapter 8
Page 108
Page 109
Page 109
Page 110
Page 110
Page 111
Page 112
Page 113
Page 113
Page 114
Page 114
Page 114
Page 117
Page 117
Page 117
Page 118
107