For Lightfield; Figure 74. Ebus Driver Installation Tool Dialog; Figure 75. Ebus Driver Installation Tool Dialog - Princeton Instruments ProEM+ EMCCD User Manual

Chapter 8
4. After making the selection, click on Install.
5. After the installation you may be asked to reboot the computer. If you are asked to
reboot, you can


6. Verify that the network connection has been re-established. If a reboot was required,
wait until the reboot has occurred before verifying the connection.

For LightField:

1. Locate the EbDriverTool64.exe file. Typically it is located at C:\Program
Files\Common Files\Pleora. The EbDriverTool64.exe file may be in a
subdirectory.
2. Run the file.
3. When this program executes, select the appropriate Ethernet card and under the
Action category, choose "Install High-Performance IP Device Driver" from the
pulldown menu.
4. After making the selection, click on Install.
5. After the installation you may be asked to reboot the computer. If you are asked to
reboot, you can
Troubleshooting

Figure 74. Ebus Driver Installation Tool dialog

Click on "Yes" to initiate the reboot.
Click on "No" to wait before rebooting. If you select "No," you may be required
to close the eBUS Driver Installation Tool dialog. Reboot the computer at your
convenience.

Figure 75. Ebus Driver Installation Tool dialog

115
115