Program Error Message; Figure 76. Program Error Dialog - Princeton Instruments ProEM+ EMCCD User Manual

116


6. Verify that the network connection has been re-established. If a reboot was required,
wait until the reboot has occurred before verifying the connection.

Program Error message

This dialog may appear if you have tried to acquire a test image, acquire data, or run in
focusing mode and the DMA buffer size is too small. A large array (for example, a
2048x2048 array), requires a larger setting than that for a smaller array (for example, a
512x512 array).
To correct the problem:
1. Click on OK .
2. Reboot WinView.
3. Note the array size (on the Setup|Hardware|Controller/CCD tab or the
4. Open Setup|Environment|Environment dialog.
5. Increase the DMA buffer size to a minimum of 32 Mb (64 Mb if it is currently
6. Reboot your computer.
7. Restart WinView and begin acquiring data or focusing. If you see the message
ProEM
Click on "Yes" to initiate the reboot.
Click on "No" to wait before rebooting. If you select "No," you may be required
to close the eBUS Driver Installation Tool dialog. Reboot the computer at your
convenience.

Figure 76. Program Error dialog

Acquisition|Experiment Setup|Main tab Full Chip dimensions). If your
camera contains a large array (such as a 2048x2048 array), and the DMA buffer
size is too small, there will not be enough space in memory for the data set.
32 Mb or 128 Mb if it is currently 64 Mb), click on OK , and close WinView.
again, increase the DMA buffer size.
®
+ System Manual Version 1.B