Upgrading To The Xt1000 With Embedded Mcu - RADVision Scopia XT1000 Administrator's Manual

Step 3
Set PODS to output to Yes.
Step 4
Select Monitor > General.
Step 5
Set Number of Monitors to HD2.
Step 6
Press

Upgrading to the XT1000 with Embedded MCU

Procedure
Step 1
Purchase the MCU4 or MCU9 option.
Note:
Step 2
Enable the license as explained in
Step 3
Set up a call to check how the system works.
RADVISION | Administrator Guide for SCOPIA XT1000 Version 2.0
Save.
We recommend purchasing the High Bandwidth Option (12Mbps) when using the
embedded MCU. If the High Bandwidth option is not enabled, the MCU will send out a
lower resolution according to the standard 4Mbps total bandwidth.
Installing and Enabling an Option License page 13.
'Initial Configuration' | 31