Maintenance Of The Rear Wheel Sensor And Sensor Rotor; Assembling The Rear Wheel - Yamaha XT1200Z(Z) 2010 Service Manual

• Oil seal
Refer to "CHECKING THE FRONT WHEEL"
on page 4-23.
2. Check:
• Tire
• Rear wheel
Damage/wear → Replace.
Refer to "CHECKING THE TIRES" on page
3-18 and "CHECKING THE WHEELS" on
page 3-17.
3. Check:
• Spokes
Refer to "CHECKING AND TIGHTENING
THE SPOKES" on page 3-17.
4. Measure:
• Radial wheel runout
• Lateral wheel runout
Refer to "CHECKING THE FRONT WHEEL"
on page 4-23.
Radial wheel runout limit
2.0 mm (0.08 in)
Lateral wheel runout limit
2.0 mm (0.08 in)
EAS22200
MAINTENANCE OF THE REAR WHEEL
SENSOR AND SENSOR ROTOR
ECA23P1016
NOTICE
• Handle the ABS components with care
since they have been accurately adjusted.
Keep them away from dirt and do not sub-
ject them to shocks.
• The rear wheel sensor cannot be disassem-
bled. Do not attempt to disassemble it. If
faulty, replace with a new one.
• Keep magnets (including magnetic pick-up
tools, magnetic screwdrivers, etc.) away
from the wheel sensor rotor.
• Do not drop or shock the wheel sensor or
the wheel sensor rotor.
1. Check:
• Rear wheel sensor
Refer to "MAINTENANCE OF THE FRONT
WHEEL SENSOR AND SENSOR ROTOR"
on page 4-24.
2. Check:
• Rear wheel sensor rotor
Refer to "MAINTENANCE OF THE FRONT
WHEEL SENSOR AND SENSOR ROTOR"
on page 4-24.
3. Measure:
• Wheel sensor rotor deflection
Refer to "MAINTENANCE OF THE FRONT
WHEEL SENSOR AND SENSOR ROTOR"
on page 4-24.
EAS22140

ASSEMBLING THE REAR WHEEL

ECA23P1018
NOTICE
• Keep magnets (including magnetic pick-up
tools, magnetic screwdrivers, etc.) away
from the wheel sensor rotor.
• Do not drop the wheel sensor rotor or sub-
ject it to shocks.
• If any solvent gets on the wheel sensor ro-
tor, wipe it off immediately.
1. Install:
• Wheel bearing
New
• Bearing
M MMM M MMM M M MMM
a. Install the new wheel bearing. (right side)
ECA23P1059
NOTICE
Do not contact the wheel bearing inner race
"1" or balls "2". Contact should be made
only with the outer race "3".
TIP
Use a socket "4" that matches the diameter of
the wheel bearing outer race.
b. Install the spacer.
c. Install the new bearing. (left side)
TIP
Place a suitable washer "1" between the socket
"2" and the bearing so that both the inner race
"3" and outer race "4" are pressed at the same
time, and then press the bearing until the inner
race makes contact with the spacer "5".
Installed depth of bearing "a"
5.9 mm (0.23 in)
4-33
REAR WHEEL
New
M M MMM M M MMM M M MMM M MMM