Troubleshooting - Yamaha XT1200Z(Z) 2010 Service Manual

EAS27140

TROUBLESHOOTING

The ignition system fails to operate (no spark or intermittent spark).
TIP
• Before troubleshooting, remove the following part(s):
1. Right side cowling
2. Right side panel
3. Air filter case
1. Check the fuses.
(Main and ignition)
Refer to "CHECKING THE FUS-
ES" on page 8-141.
OK ↓
2. Check the battery.
Refer to "CHECKING AND
CHARGING THE BATTERY" on
page 8-142.
OK ↓
3. Check the spark plugs.
Refer to "CHECKING THE SPARK
PLUGS" on page 3-4.
OK ↓
4. Check the ignition spark gap.
Refer to "CHECKING THE IGNI-
TION SPARK GAP" on page 8-148.
NG ↓
5. Check the ignition coils.
Refer to "CHECKING THE IGNI-
TION COILS" on page 8-147.
OK ↓
6. Check the crankshaft position sen-
sor.
Refer to "CHECKING THE CRANK-
SHAFT POSITION SENSOR" on
page 8-148.
OK ↓
7. Check the main switch.
Refer to "CHECKING THE
SWITCHES" on page 8-137.
OK ↓
8. Check the engine stop switch.
Refer to "CHECKING THE
SWITCHES" on page 8-137.
OK ↓
NG →
Replace the fuse(s).
NG →
• Clean the battery terminals.
• Recharge or replace the battery.
NG →
Re-gap or replace the spark plug(s).
OK →
Ignition system is OK.
NG →
Replace the ignition coil(s).
NG →
Replace the crankshaft position sensor.
NG →
Replace the main switch/immobilizer unit.
NG →
The engine stop switch is faulty. Replace
the right handlebar switch.
8-4
IGNITION SYSTEM