Removing The Rear Wheel (Disc); Checking The Rear Wheel; Maintenance Of The Rear Wheel Sensor And Sensor Rotor; Adjusting The Rear Wheel Static Balance - Yamaha MBK X-MAX 300 2017 Service Manual

EAS30156

REMOVING THE REAR WHEEL (DISC)

ECA21030
NOTICE
• Keep any type of magnets (including mag-
netic pick-up tools, magnetic screwdrivers,
etc.) away from the rear wheel sensor or
rear wheel sensor rotor; otherwise, the sen-
sor or rotor may be damaged, resulting in
improper performance of the ABS system.
• Do not drop the rear wheel sensor rotor or
subject it to shocks.
• If any solvent gets on the rear wheel sensor
rotor, wipe it off immediately.
1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
TIP
Place the vehicle on the centerstand so that the
rear wheel is elevated.
EAS30159

CHECKING THE REAR WHEEL

1. Check:
• Tire
• Rear wheel
Damage/wear → Replace.
Refer to "CHECKING THE TIRES" on page
3-14 and "CHECKING THE WHEELS" on
page 3-13.
2. Measure:
• Radial wheel runout
• Lateral wheel runout
Refer to "CHECKING THE FRONT WHEEL"
on page 4-29.
Radial wheel runout limit
1.0 mm (0.04 in)
Lateral wheel runout limit
1.0 mm (0.04 in)
EAS30167
MAINTENANCE OF THE REAR WHEEL
SENSOR AND SENSOR ROTOR
ECA21060
NOTICE
• Handle the ABS components with care
since they have been accurately adjusted.
Keep them away from dirt and do not sub-
ject them to shocks.
• The rear wheel sensor cannot be disassem-
bled. Do not attempt to disassemble it. If
faulty, replace with a new one.
• Keep any type of magnets (including mag-
netic pick-up tools, magnetic screwdrivers,
etc.) away from the rear wheel sensor or
rear wheel sensor rotor.
• Do not drop or shock the wheel sensor or
the wheel sensor rotor.
1. Check:
• Rear wheel sensor
Refer to "MAINTENANCE OF THE FRONT
WHEEL SENSOR AND SENSOR ROTOR"
on page 4-30.
2. Check:
• Rear wheel sensor rotor
Refer to "MAINTENANCE OF THE FRONT
WHEEL SENSOR AND SENSOR ROTOR"
on page 4-30.
EAS30164
ADJUSTING THE REAR WHEEL STATIC
BALANCE
TIP
• After replacing the tire, wheel or both, the rear
wheel static balance should be adjusted.
• Adjust the rear wheel static balance with the
brake disc installed.
1. Adjust:
• Rear wheel static balance
Refer to "ADJUSTING THE FRONT WHEEL
STATIC BALANCE" on page 4-31.
EAS32332

INSTALLING THE REAR WHEEL SENSOR

1. Install:
• Rear wheel sensor
(to rear wheel sensor bracket)
• Rear wheel sensor bracket "1"
Rear wheel sensor bolt
7 N·m (0.7 kgf·m, 5.2 lb·ft)
Rear wheel sensor bracket bolt
10 N·m (1.0 kgf·m, 7.4 lb·ft)
TIP
Face the projection "a" on the rear wheel sensor
bracket outward.
4-35
REAR WHEEL