Yamaha XT1200Z(Z) 2010 Service Manual page 254

• Align the mating surfaces of the clutch master
cylinder holder with the punch mark "b" on the
handlebar.
• First, tighten the front bolt, then the rear bolt.
a
9. Install:
• Handlebar grip "1"
• Left grip end "2"
• Left hand shield "3"
Left grip end bolt
27 Nm (2.7 m·kgf, 20 ft·lbf)
Left upper hand shield bolt
3.8 Nm (0.38 m·kgf, 2.8 ft·lbf)
Left lower hand shield bolt
4.5 Nm (0.45 m·kgf, 3.3 ft·lbf)
LOCTITE®
M MMM M MMM M M MMM M
a. Apply a thin coat of rubber adhesive onto the
end of the left handlebar.
b. Slide the handlebar grip over the end of the
left handlebar.
TIP
Make sure that the distance "a" between the end
of the handlebar and the end of the handlebar
grip is 11–13 mm (0.43–0.51 in).
a
c. Wipe off any excess rubber adhesive with a
clean rag.
EWA13700
WARNING
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
d. Install the left grip end and left hand shield.
2 1
b
M MMM M M MMM M M MMM M
1
TIP
There should be 1–3 mm (0.04–0.12 in) of clear-
ance "b" between the handlebar grip and the grip
end.
3
b
L LLL L LLL L
10.Adjust:
• Throttle cable free play
Refer to "CHECKING THE THROTTLE GRIP
OPERATION" on page 3-31.
MMM
4-81
HANDLEBAR
2 1
L LLL L L LLL L L LLL L
Throttle cable free play
3.0–5.0 mm (0.12–0.20 in)
L LLL L LLL