Yamaha XT1200Z(Z) 2010 Service Manual page 123

AA.Route the stator coil lead over the wire harness.
AB.Fasten the stator coil lead, wire harness, wire
harness (starting circuit cut-off relay lead and
starter relay lead), and wire harness
(rectifier/regulator lead and stator coil lead) with
the plastic band. Route the leads in the order
shown in the illustration. Point the end of the plastic
band downward. Do not cut off the excess end of
the plastic band.
AC.Position the rubber cover at the location shown in
the illustration.
AD.Route the O sensor #1 lead, left handlebar switch
2
lead, and right handlebar switch lead to the outside
of the wire harness (turn signal/hazard relay lead
and radiator fan motor relay lead).
AE.Route the stator coil lead to the inside of the wire
harness (starting circuit cut-off relay lead and
starter relay lead).
AF. Route the stator coil lead to the outside of the ECU
leads, headlight relay lead, turn signal/hazard relay
lead, fuse box 1 lead, fuse box 2 lead, and leads
that pass through the rubber cover.
AG.Route the left handlebar switch lead and right
handlebar switch lead to the outside of the O
sensor #2 lead and main switch lead.
AH.Connect the crankshaft position sensor coupler
and negative battery lead coupler, making sure
that the leads are not twisted.
AI. Route the O sensor #1 lead and O
2
lead under the negative battery lead.
AJ. Route the starter relay lead and negative battery
lead over the wire harness.
AK.Fasten the O sensor #1 lead, O
2
and wire harness with the holder. Face the catch of
the holder rearward.
AL. Align the white tape on the wire harness with the
holder.
2
sensor #2
2
sensor #2 lead,
2
2-62
CABLE ROUTING