Yamaha XT1200Z(Z) 2010 Service Manual page 208

a
1
5. Tighten:
• Brake torque rod bolts
• Rear wheel axle nut
• Rear wheel axle pinch bolt
Brake torque rod bolt
30 Nm (3.0 m·kgf, 22 ft·lbf)
Rear wheel axle nut
125 Nm (12.5 m·kgf, 90 ft·lbf)
Rear wheel axle pinch bolt
25 Nm (2.5 m·kgf, 18 ft·lbf)
6. Measure:
TIP
Measure the distance "a" only if the wheel bear-
ings, wheel sensor rotor, or both were replaced.
• Distance "a"
(between the wheel sensor rotor "1" and
wheel sensor housing "2")
Out of specification → Reinstall the bearing
or replace the wheel sensor rotor.
Distance "a" (between the wheel
sensor rotor and wheel sensor
housing)
18.0–18.2 mm (0.71–0.72 in)
1
7. Install:
• Rear wheel sensor
Rear wheel sensor bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
2
b
a
2
ECA23P1017
NOTICE
To route the rear wheel sensor lead, refer to
"CABLE ROUTING" on page 2-43.
TIP
When installing the rear wheel sensor, check the
rear wheel sensor lead for twists and the sensor
electrode for foreign materials.
8. Check:
• Rear wheel sensor installation
Check if the wheel sensor housing is installed
properly.
4-35
REAR WHEEL