Yamaha XT1200Z(Z) 2010 Service Manual page 291

Recommended lubricant
Molybdenum disulfide grease
2. Lubricate:
• Drive shaft spline (universal joint side)
Recommended lubricant
Lithium-soap-based grease
3. Install:
• Oil seal "1" New
• Washer "2"
(to the drive shaft with the fork seal driver
weight "3" and fork seal driver attachment (ø
30) "4")
Fork seal driver weight
90890-01367
Replacement hammer
YM-A9409-7
Fork seal driver attachment (ø30)
90890-01400
4. Install:
New
• Circlips
5. Install:
• Drive shaft assembly "1"
(to the final gear case with the fork seal driver
weight "2" and fork seal driver attachment
(ø38) "3")
Fork seal driver weight
90890-01367
Replacement hammer
YM-A9409-7
Fork seal driver attachment (ø38)
90890-01372
Replacement 38 mm
YM-A5142-1
Installed depth "a"
8.5–10.0 mm (0.33–0.39 in)
6. Install:
TIP
3
Align the drive shaft splines with the driven yoke
of the universal joint.
4
7. Tighten:
2
1
New
8. Install:
9. Fill:
4-118
4
4. Oil seal
• Final drive assembly
• Final drive assembly nuts
Final drive assembly nut
42 Nm (4.2 m·kgf, 30 ft·lbf)
• Rear wheel
Refer to "REAR WHEEL" on page 4-29.
• Final gear case
Refer to "CHECKING THE FINAL GEAR OIL
LEVEL" on page 3-29.
SHAFT DRIVE
2
1
3
a