Checking The Lean Angle Sensor; Checking The Starter Motor Operation - Yamaha XT1200Z(Z) 2010 Service Manual

Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
• Positive tester probe →
black "1"
• Negative tester probe →
gray "2"
1
b. Measure the crankshaft position sensor re-
sistance.
L LLL L LLL L L LLL L
EAS28131

CHECKING THE LEAN ANGLE SENSOR

1. Remove:
• Lean angle sensor
2. Check:
• Lean angle sensor output voltage
Out of specification → Replace.
Lean angle sensor output voltage
Less than 45°
0.4–1.4 V
More than 45°
3.7–4.4 V
M MMM M MMM M M MMM M
a. Connect the test harness-lean angle sensor
(6P) between the lean angle sensor and wire
harness.
b. Connect the pocket tester (DC 20 V) to the
test harness-lean angle sensor (6P).
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
Test harness- lean angle sensor
(6P)
90890-03209
YU-03209
B Gy
2
L LLL L L LLL L L LLL L
M MMM M M MMM M M MMM M
ELECTRICAL COMPONENTS
• Positive tester probe →
yellow/green "1"
• Negative tester probe →
black/blue "2"
c. Turn the main switch to "ON".
d. Turn the lean angle sensor to 45°.
e. Measure the lean angle sensor output volt-
age.
L LLL L LLL L
EAS28940
CHECKING THE STARTER MOTOR
OPERATION
LLL
1. Check:
• Starter motor operation
Does not operate → Perform the electric
starting system troubleshooting, starting with
step 4.
Refer to "TROUBLESHOOTING" on page
8-10.
M MMM M MMM M
a. Connect the positive battery terminal "1" and
starter motor lead "2" with a jumper lead "3".
EWA13810
WARNING
• A wire that is used as a jumper lead must
have at least the same capacity of the bat-
tery lead, otherwise the jumper lead may
MMM
burn.
• This check is likely to produce sparks,
therefore, make sure no flammable gas or
fluid is in the vicinity.
8-149
45
45
L LLL L L LLL L L LLL L
M MMM M M MMM M M MMM M
L LLL L LLL
M MMM M MMM