Installing The Front Wheel (Front Brake Discs) - Yamaha XT1200Z(Z) 2010 Service Manual

c. If the heavy spot does not stay in that posi-
tion, install a heavier weight.
d. Repeat steps (b) and (c) until the front wheel
is balanced.
TIP
Install up to four balancing weights on the rim.
When installing three or four balancing weights,
install the third and fourth weights on the oppo-
site side of the rim.
L LLL L LLL L L LLL L
4. Check:
• Front wheel static balance
M MMM M MMM M M MMM M
a. Turn the front wheel and make sure it stays at
each position shown.
b. If the front wheel does not remain stationary
at all of the positions, rebalance it.
L LLL L LLL L L LLL L
EAS22000
INSTALLING THE FRONT WHEEL (FRONT
BRAKE DISCS)
1. Install:
• Front brake discs
Front brake disc bolt
18 Nm (1.8 m·kgf, 13 ft·lbf)
LOCTITE®
TIP
Tighten the brake disc bolts in stages and in a
crisscross pattern.
L LLL L L LLL L L LLL L
M MMM M M MMM M M MMM M
L LLL L L LLL L L LLL L
2. Check:
• Front brake discs
Refer to "CHECKING THE FRONT BRAKE
DISCS" on page 4-44.
3. Lubricate:
• Oil seal lips
4. Install:
LLL
• Collars
• Front wheel sensor housing
• Front wheel
MMM
TIP
Align the slot "a" in the front wheel sensor hous-
ing with the projection "b" of the front fork before
assembly.
LLL
5. Install:
• Front wheel axle
• Front wheel axle pinch bolts
ECA23P1011
NOTICE
Before tightening the wheel axle, push down
hard on the handlebars several times and
check if the front fork rebounds smoothly.
4-27
FRONT WHEEL
Recommended lubricant
Lithium-soap-based grease
Front wheel axle
72 Nm (7.2 m·kgf, 52 ft·lbf)
Front wheel axle pinch bolt
21 Nm (2.1 m·kgf, 15 ft·lbf)
b
a