Yamaha XT1200Z(Z) 2010 Service Manual page 117

1. Stator coil lead
2. Clutch hose
3. Brake hose (front brake master cylinder to
hydraulic unit)
4. Brake hose (hydraulic unit to left front brake
caliper)
5. Oil level switch lead
6. Fuel tank overflow hose
7. Fuel tank breather hose
8. Sidestand switch lead
9. Engine ground lead
10. Starter motor lead
11. Brake hose (hydraulic unit to rear brake caliper)
12. Rear wheel sensor lead
13. Rear brake light switch lead
14. Neutral switch lead
15. Coolant reservoir breather hose
16. Brake hose (rear brake master cylinder to
hydraulic unit)
17. Coolant reservoir hose
A. Fasten the brake hose (hydraulic unit to left front
brake caliper), oil level switch lead, and sidestand
switch lead with the holder. Position the holder
between the brake hose flare nut and the grommet
on the hose.
B. Fasten the clutch hose, oil level switch lead, and
sidestand switch lead with the holder. Position the
holder in the middle of the hose protector on the
clutch hose.
C. Route the sidestand switch lead to the outside of
the oil level switch lead, and then fasten the leads
with the holder.
D. Route the sidestand switch lead to the outside of
the oil level switch lead, and then fit the leads in
between the generator cover and the middle gear
side cover.
E. Make sure that the stator coil lead is covered
completely by the protective sleeve and rubber
boot.
F. To electrical components tray
G. Route the engine ground lead, stator coil lead, and
starter motor lead to the outside of the timing chain
tensioner.
H. Fasten the stator coil lead and starter motor lead
with the holder.
I. Route the starter motor lead over the stator coil
lead.
J. To stator coil
K. Route the rear wheel sensor lead and rear brake
light switch lead between the brake hose (rear
brake master cylinder to hydraulic unit) and the
brake hose (hydraulic unit to rear brake caliper).
L. Install the neutral switch lead terminal so that the
lead is routed in the direction shown in the
illustration.
M. Route the neutral switch lead to the front of the
brake hose (rear brake master cylinder to hydraulic
unit) and brake hose (hydraulic unit to rear brake
caliper).
N. The catch of the holder may be facing in any
direction.
O. Face the catch of the holder inward.
P. Route the oil level switch lead and sidestand
switch lead to the inside of the clutch hose.
Q. Route the fuel tank overflow hose and fuel tank
breather hose so that the hoses cross no more
than once between the fuel tank and the holder.
2-56
CABLE ROUTING