Maintenance Of The Front Wheel Sensor And Sensor Rotor - Yamaha XT1200Z(Z) 2010 Service Manual

• Front wheel
Damage/wear → Replace.
Refer to "CHECKING THE TIRES" on page
3-18 and "CHECKING THE WHEELS" on
page 3-17.
3. Check:
• Spokes
Bends/damage → Replace.
Loose → Tighten.
Refer to "CHECKING AND TIGHTENING
THE SPOKES" on page 3-17.
TIP
After tightening the spokes, measure the front
wheel runout.
4. Measure:
• Front wheel radial runout "1"
• Front wheel lateral runout "2"
Over the specified limits → Replace.
Radial wheel runout limit
2.0 mm (0.08 in)
Lateral wheel runout limit
2.0 mm (0.08 in)
5. Check:
• Wheel bearings
Front wheel turns roughly or is loose → Re-
place the wheel bearings.
• Oil seals
Damage/wear → Replace.
2
1
EAS22010
MAINTENANCE OF THE FRONT WHEEL
SENSOR AND SENSOR ROTOR
ECA23P1006
NOTICE
• Handle the ABS components with care
since they have been accurately adjusted.
Keep them away from dirt and do not sub-
ject them to shocks.
• The front wheel sensor cannot be disas-
sembled. Do not attempt to disassemble it.
If faulty, replace with a new one.
• Keep magnets (including magnetic pick-up
tools, magnetic screwdrivers, etc.) away
from the wheel sensor rotor.
• Do not drop or shock the wheel sensor or
the wheel sensor rotor.
1. Check:
• Front wheel sensor "1"
Cracks/bends/distortion → Replace.
Iron powder/dust → Clean.
1
2. Check:
• Front wheel sensor rotor "1"
Cracks/damage/scratches → Replace the
front wheel sensor rotor.
Iron powder/dust/solvent → Clean.
TIP
• The wheel sensor rotor is installed on the inner
side of the wheel hub.
• When cleaning the wheel sensor rotor, be
careful not to damage the surface of the rotor
magnet.
4-24
FRONT WHEEL
1