Installing The Throttle Body Joints - Yamaha XT1200Z(Z) 2010 Service Manual

M MMM M MMM M M MMM M
a. Temporary tighten the accelerator position
sensor.
b. Check that the throttle valves are fully closed.
c. Connect the accelerator position sensor to
the wire harness.
d. Connect the throttle cables to the throttle bod-
ies.
e. Turn the main switch to "OFF".
f. Simultaneously press and hold the left set
button "1" and right set button "2", turn the
main switch to "ON", and continue to press
the buttons for 8 seconds more.
1
TIP
"dIAG" appears on the odometer LCD.
g. Diagnostic code number "d:14" is selected.
h. Turn the throttle grip to the fully closed posi-
tion.
i. Adjust the position of the accelerator position
sensor angle so that 12–22 can appear in the
meter.
j. After adjusting the accelerator position sen-
sor angle, tighten the accelerator position
sensor screws "3".
Accelerator position sensor
screw
3.5 Nm (0.35 m·kgf, 2.5 ft·lbf)
3
k. Turn the throttle grip to the fully open position.
M MMM M M MMM M M MMM M
2
MMM l. Check the meter display value. If the meter
display value is not 97–113, adjust the accel-
erator position sensor angle.
m. Select the diagnostic code number "d:15".
n. Turn the throttle grip to the fully closed posi-
tion.
o. Check the meter display value. If the meter
display value is not 9–25, adjust the acceler-
ator position sensor angle.
p. Turn the throttle grip to the fully open position.
q. Check the meter display value. If the meter
display value is not 97–113, adjust the accel-
erator position sensor angle.
r. Repeat steps (g) to (q) until the meter display
values are within the specified ranges.
s. If the meter display values are not within the
specified ranges after repeating steps (g) to
(q) several times, replace the accelerator po-
sition sensor.
L LLL L LLL L
EAS23P1086

INSTALLING THE THROTTLE BODY JOINTS

1. Install:
• Throttle body joints "1"
TIP
Be sure to install the throttle body joint with the
"L" mark onto the throttle body openings for cyl-
inders #1 and the joint with the "R" mark onto the
openings for cylinders #2.
L
7-13
THROTTLE BODIES
L LLL L L LLL L L LLL L
Throttle body joint bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
R
1
L LLL L LLL