Yamaha XT1200Z(Z) 2010 Service Manual page 111

AA.Route the immobilizer unit lead to the inside of the
throttle cables.
AB.Position the immobilizer unit coupler below the
brake hose (front brake master cylinder to
hydraulic unit).
AC.Upward
AD.Route the throttle cables between the brake hose
(front brake master cylinder to hydraulic unit) and
the clutch hose.
AE.Route the front wheel sensor lead to the outside of
the brake hose (front brake master cylinder to
hydraulic unit), clutch hose, and throttle cables.
AF. Route the radiator fan motor lead over the front
wheel sensor lead.
AG.Route the horn lead between the brake hose (front
brake master cylinder to hydraulic unit) and the
clutch hose, and to the inside of the throttle cables.
AH.Forward
AI. Face the buckle of the plastic band rearward with
the end pointing downward. Do not cut off the
excess end of the plastic locking tie.
AJ. Fasten the immobilizer unit lead at the white tape
to the brake hose (front brake master cylinder to
hydraulic unit) with a plastic locking tie. Face the
buckle of the plastic locking tie forward with the end
pointing downward. Do not cut off the excess end
of the plastic locking tie.
2-50
CABLE ROUTING