Replacing A Power Distribution Module - Gateway 9510 User Manual

Replacing a power distribution module

Your server uses a power distribution module to enable the hot-swap capability and
distribute power to the system. If the power distribution module fails, you will need to
turn off the server and disconnect all AC power to the system prior to replacing it.
To replace a power distribution module:
1
Follow the instructions in
2
Follow the instructions in
3
Remove the power supply module (remove both if two are installed) by following the
instructions in
4
Follow the instructions in
5
Disconnect all power cables from chassis components and the system board, noting
their locations and orientation. (You will reconnect the cables after you install the
new module.)
6
Remove the screw securing the power supply module bay center divider to the power
supply cage.
7
Push the center divider toward the front of the chassis and tilt it to the right to
disengage the mounting tabs from the chassis slots, then remove the divider from
the power supply cage.
"Preventing static electricity discharge" on page
"Opening the server case" on page
"Replacing a power supply module" on page
"Removing the air ducts" on page
www.gateway.com
Replacing a power distribution module
42.
81.
46.
41.
83