Gateway 9510 User Manual page 168

Your server does not recognize a SCSI drive
Make sure that the SCSI controller is enabled in the BIOS Setup utility.
■
Reinstall the device driver. For more information, see Using Your System Companion
■
CD.
Change the drive's SCSI address to one that is not being used by your server. For
■
more information about SCSI device configurations, see your drive's
documentation.
Run SCSI Verify in the SCSI BIOS. For more information about the SCSI BIOS, see
■
the SCSI controller's documentation.
Reseat the drive.
■
Open your server and reseat the drive controller card. Also make sure that the
■
controller card and power cables are connected to the drive. For more information,
see "Installing PCI expansion cards" on page 69
documentation.
Make sure that the power cable and SCSI cable are attached securely to the drive
■
cage.
Make sure that the last device on the SCSI cable is correctly terminated. For more
■
information about SCSI device configurations, see the device's documentation.
■ Use a different SCSI cable.
You are having problems with a SATA drive
For normal SATA drives (not SATA RAID), check the BIOS setup utility to see if the
■
BIOS has recognized the drive.
Make sure that the power cable and SATA cables are attached securely to the drive
■
cage.
If the drive is not detected, try a different SATA port.
■
Try swapping SATA cables between drives to determine if the cable is defective.
■
Try listening to the drive to determine if the drive is spinning up. If not, the drive
■
may be defective.
The master boot record is corrupted
■ In a Windows network operating system, repair the master boot record using FDISK.
To repair the master boot record:
At a DOS command prompt, type fdisk/mbr, then press E
■
www.gateway.com
Troubleshooting
or your controller card's
.
NTER
163