Table of Contents
Advertisement
Chapter 3: Maintaining Your Server
Caution
2
Follow the instructions in
3
Follow the instructions in
4
Move the shorting block from pins 2-3 to pins 1-2 on the Boot Block Update jumper
(J1B1) on the IMM module.
J2B1
5
Move the shorting block from pins 1-2 to pins 2-3 on the Force Update jumper (J2B1)
on the IMM module.
6
Follow the instructions in
7
Follow the instructions in
power cord.
36
If you do not disconnect the power cords when instructed to in this
procedure, the BMC firmware will not update.
"Opening the server case" on page
"Removing the air ducts" on page
1
2
3
J1B1
1
2
3
3
2
1
3
2
1
"Installing the air ducts" on page
"Closing the server case" on page
www.gateway.com
2 - 3 Default - Boot block
1 - 2 Boot block unprotected
1 - 2 Default - No forced update
2 - 3 Force update
42.
46.
protected
47.
52, then reconnect the
Advertisement
Table of Contents
Troubleshooting
