Check Rebuild Rate
Select the correct adapter from the
If there is more than one adapter in the system, click each adapter and check the rebuild
rate. The rebuild rate is not affected when you clear the configuration.
Exit Web Console
Select
from the Configuration menu to quit the Web Console.
Exit
Reclaiming Hot Spare Disks
To reclaim hot spare disks during normal operation, select the drive and select
from the right pane. The Web Console changes the state of the selected drives
Hot Spare
to the READY state.
Reconfiguring Existing Arrays
This section provides instructions for adding and removing physical drives from existing
arrays.
Adding a Physical Drive to an Existing Array
To add a physical drive to an array:
1
Go to the Config View screen.
2
Highlight the logical drive and select properties from the left pane. Select the drive
to add from the
Removing a Physical Drive from an Array
To selectively remove hard drives from an existing array:
1
Go to the Config View screen.
2
Highlight the logical drive you want to remove, then select
Adapter
pane.
Add Physical Drive
www.gateway.com
Launching the Web Console
box. Select
Rebuild Rate
from the Adapter menu.
Remove
from the left pane.
Delete
143