Table of Contents
Advertisement
Chapter 4: Installing Components
IDE drives can be configured as master, slave, or cable-select.
■
If cable-select is available (drive assignments will be marked on the cable), the
■
IDE cable assigns the master/slave positions to the drives it connects. You can
override these assignments using the jumpers on the drives.
If cable-select is not available and only one drive is attached to an IDE controller
■
cable, configure the drive as master if it is a CD or DVD drive. If two drives of
any type are attached to the cable, configure one as master and one as slave.
■
You may need to configure the drives you install using the BIOS Setup utility. Press
F2 at startup to open the BIOS Setup utility.
Installing or replacing a fixed, removable-media drive
Use these instructions to install or replace a diskette, CD, DVD, or tape drive.
To install a 5.25-inch drive:
1
Follow the instructions in
2
Follow the instructions in
3
Follow the instructions in
4
If you are replacing a drive, go to
- OR -
If you are adding a new drive to an available 5.25-inch device bay, remove the
slide/filler panel assembly from the bay by pressing and holding the two locking clips
inward, then pulling the assembly out of the bay.
5
Remove the drive rails from the filler panel assembly.
54
"Preventing static electricity discharge" on page
"Opening the server case" on page
"Removing the bezel assembly" on page
Step
8.
www.gateway.com
41.
42.
44.
Advertisement
Table of Contents
Troubleshooting
