Table of Contents
Advertisement
Chapter 4: Installing Components
7
Grasp the IMM module board by the edges (close to the mounting connector), align
the board with the IMM connector on the system board, then gently apply pressure
to seat the module.
Make sure the module is fully seated and the nylon standoffs are inserted into the
corresponding holes in the system board.
8
Update the base management controller firmware by following the instructions in
"Updating the baseboard management controller firmware" on page
9
Update the FRU/SDR by following the instructions in
page
37).
10
Reinstall the GSM software (from a CD which accompanied your server). When you
subsequently reboot your server, the GSM software will take over management of the
server.
78
www.gateway.com
35.
"Updating the FRU/SDR" on
Advertisement
Table of Contents
Troubleshooting
