Table of Contents
Advertisement
Chapter 4: Installing Components
6
Insert the activation key into its socket on the system board (see
page 7
for the location of the socket.)
Push it into the socket until it is below the two retaining clips.
7
Pull the plastic tabs away from the sides of the DIMM socket. If you are replacing a
DIMM, remove the old one.
8
Holding the DIMM (or portable cache module with battery) by the edges, align the
notch on the bottom edge of the DIMM with the notch in the DIMM socket and press
it firmly into the socket. The tabs on the sides of the DIMM socket should secure the
DIMM automatically.
9
Replace the PCI expansion card in PCI slot 1 (if removed) by following the instructions
in
"Installing PCI expansion cards" on page
10
Follow the instructions in
11
Follow the instructions in
12
Configure the BIOS settings to enable the ROMB option.
80
69.
"Installing the air ducts" on page
"Closing the server case" on page
www.gateway.com
"System board" on
47.
52.
Advertisement
Table of Contents
Troubleshooting
