Chapter 4: Installing Components
2
Close the bezel door.
3
With the bezel assembly at a 40 degree angle from the chassis, engage the three bezel
retention hooks on the right side of the bezel assembly with the raised metal slots in
the right front edge of the chassis.
Caution
4
Rotate the bezel assembly toward the chassis until the two plastic tabs on the left side
of the bezel assembly snap into place.
5
Relock the bezel, if required.
50
If the bezel assembly is angled at more than 40 degrees from the
chassis, you may damage or break off the retention hooks on the right
side of the bezel assembly.
www.gateway.com
40 ˚ Max