Replacing The Power Distribution Module - Gateway 9515 User Manual

Replacing the power distribution module

To replace the power distribution module:
1
Follow the instructions in
sure you turn off the server, then unplug the power cord and all other cables connected
to the server.
2
Follow the instructions in
3
Follow the instructions in
4
Remove the power supply modules by following the instructions in
power supply module" on page
5
Remove the PCI riser assembly by following the instructions in
installing the PCI riser assembly" on page
6
Disconnect the flat flex cable from the hot-swap backplane to the system board.
Flat flex
96
"Preventing static electricity discharge" on page
"Opening the server case" on page
"Removing the air baffles" on page
cable
94.
79.
www.gateway.com
43. Make
44.
50.
"Replacing a
"Removing and