Installing A Local Control Panel (Lcp) - Gateway 9510 User Manual

Chapter 4: Installing Components

Installing a local control panel (LCP)

To install a local control panel:
1
Follow the instructions in
2
Follow the instructions in
3
Follow the instructions in
4
Remove the filler panel from an empty 5.25-inch drive bay by pressing and holding
the two locking clips inward, then pulling the filler panel assembly out of the bay.
5
Remove the drive rails from the filler panel assembly.
6
Attach the drive rails to the LCP panel tray by pressing the rails firmly into the dimples
on each side of the tray.
64
"Preventing static electricity discharge" on page
"Opening the server case" on page
"Removing the bezel assembly" on page
www.gateway.com
41.
42.
44.