Table of Contents
Advertisement
www.gateway.com
Replacing the RPS power distribution module
Important
Make sure that the RPS power
distribution module is connected to the
power supply connector(s) on the power
To replace the RPS power distribution module:
Follow the instructions in
1
page
cord(s) and all other cables connected to the server.
Follow the instructions in
2
Remove the power supply modules by following the instructions in
3
"Replacing a power supply module" on page
Disconnect the main power, CPU power, backplane power, I
4
midplane power cables. See
the connectors on the system board.
Push down the release bar (1). When the RPS power distribution module
5
lifts (automatically), pull it away from the power supply cage (2) and
remove it from the chassis.
Align the new RPS power distribution module with the power supply cage
6
(1), then push it down (2) onto the release bar. Make sure that the
connectors on the back of the RPS power distribution module fit into the
connectors on the power supply(ies).
supply(ies).
Reconnect the power cables. See
7
location of the connectors on the system board.
Reinstall the power supply modules by following the instructions in
8
"Replacing a power supply module" on page
Follow the instructions in
9
"Preventing static electricity discharge" on
30. Make sure that you turn off the server, then unplug the power
"Opening the server case" on page
"Closing the server case" on page
Replacing the RPS power distribution module
52.
"System board" on page 6
"System board" on page 6
52.
31.
2
C power, and
for the location of
for the
32.
53
Advertisement
Table of Contents
Troubleshooting
