Error Messages - Gateway 9510 User Manual

Error messages

These messages often indicate procedural errors such as typing an incorrect keystroke or
trying to save a file to a write-protected diskette. Some messages, however, may indicate
a problem that requires further troubleshooting. These are general messages and do not
represent all possible error messages you might receive.
Diskette drive 0 seek to track 0 failed
■
Restart your server, then open the BIOS Setup utility by pressing and holding F2
while your server restarts. Make sure that the drive settings are correct.
Error loading operating system
■ The master boot record may be corrupt. For troubleshooting information, see
master boot record is corrupted" on page
Hard disk controller failure
Make sure that the data cables to the hot swap hard drive cage are connected
■
securely.
■ Restart your server, then open the BIOS Setup utility by pressing and holding F2
while your server restarts. Make sure that the correct drive type is selected.
Hard disk controller failure - press F1 to try reboot
The drive controller may be defective. Press F1 to try to restart the server. For more
■
information about running diagnostics on your hard drive, see your operating
system's documentation.
Insert bootable media device
Restart your server, then open the BIOS Setup utility by pressing and holding F2
■
while your server restarts. Make sure that the correct hard drive is set as the first
bootable drive in the Boot menu.
■ See "Your server does not recognize a SCSI drive" on page 163
solution.
Invalid configuration information
Restart your server, then open the BIOS Setup utility by pressing and holding F2
■
while your server restarts. Make sure that the settings are correct.
■ Reset the BIOS. For more information, see
Invalid partition table
■
The master boot record may be corrupt. For troubleshooting information, see
master boot record is corrupted" on page
163.
"Resetting the BIOS" on page
163.
www.gateway.com
Error messages
"The
for a possible
105.
"The
147