Replacing The Power Distribution Board - Gateway 9415 User Manual

Replacing the power distribution board

To replace the power distribution board:
1
Follow the instructions in
sure that you turn off the server, then unplug the power cord(s) and all other cables
connected to the server.
2
Follow the instructions in
3
Follow the instructions in
4
Remove the power supply modules by following the instructions in
power supply module" on page
5
Disconnect the main power, CPU power, and power signal cables from the system
board. See
board.
6
Disconnect the PCI fan from the power distribution board.
7
Disconnect the power cables from the power distribution board and the hot-swap
backplane.
8
Disconnect the drive cables and drive power cables from the backplane.
90
"Preventing static electricity discharge" on page
"Opening the server case" on page
"Removing the power supply air duct" on page
"System board" on page 6
88.
for the location of the connectors on the system
www.gateway.com
41. Make
42.
49.
"Replacing a