Gateway 9510 User Manual page 80

9
Install the new processor into the processor socket. Make sure that:
The processor release lever is open all the way (135° from the closed position)
■
The triangular arrow on the corner of the processor aligns with the triangular
■
hole on the corner of the processor socket
The processor is flush with the socket.
■
Important
10
Press the processor locking lever down until it clicks into place.
11
Place the heat sink on the processor, making sure the Thermal Interface Material (TIM)
is aligned between the heat sink and the processor.
12
Line up the four captive screws with the four posts surrounding the processor, then
gradually and evenly tighten the four captive screws to secure the heat sink to the
system board.
13
Follow the instructions in
14
Follow the instructions in
If you install two processors onto the system board, for best
performance the processors should be the same speed. Otherwise,
applications that detect processor speed could cause problems.
If only one processor is installed, it must be installed in the CPU 1
socket.
"Installing the air ducts" on page
"Closing the server case" on page
www.gateway.com
Installing a processor
47.
52.
75