Installing The Touch Panel Driver For Ms-Dos - Epson MR Series Technical Reference Manual

4. Click Add/Remove.
5. The Uninstall Universal Pointer Device Driver dialog box is displayed. Click Next.
6. The Uninstall Completed dialog box is displayed. Click Finish.
7. The dialog box to require rebooting the system is displayed. Click Yes and reboot the
system.

Installing the Touch Panel Driver for MS-DOS

Note
Be sure to set the touch panel driver to COM1 or COM2. COM3/COM4 cannot be used.
This is installed by the exclusive installation program.
1. Insert the touch panel driver CD-ROM for the DM-M820 to the CD-ROM drive. Start
\Dos\INSTALL.EXE.
2. The touch screen screen is displayed. Select AHL/AR5000 and Digitouch Controllers by
using the cursor keys, and press Enter.
3. The Installation Options screen is displayed. Normally, leave the default setting as it is. To
change the setting, select the item to be selected by using the cursor keys, and press Enter.
The setting contents are changed. Select Start Installation, and press Enter to start copying
the file to C:\TOUCH directory.
4. After copying is complete, press any key. The hardware setting is displayed.
5. Press any key. Readme is displayed.
6. Press Esc to terminate installation.
7. Enter the following from the prompt to install the driver:
For example: Set to COM2
TTDOS 2 /I:3 Enter
TBMOUSE 1 Enter
TT-DOS Command Line
TTDOS [Port] [/A:address] [/C:bbbb,p,s][/I]
Port:
/A:Address:
/C:bbbb,p,d,s
bbbb:
p:
d:
s:
/I:Irq.
Rev. I
Specifies the serial port [Default:1]
Port address [Default: 3F8]
Communications parameters
Baudrate [Default: 9600]
Parity (N,O,E) [Default: N]
Data bit (7,8) [Default: 8]
Stop bit (1,2) [Default: 1]
Interrupt request number (0 to 15)
MR Series Technical Reference Manual
OS and Drivers 4-49